2

sSpecifications

Item

Specification

Conditions

1. Contact resistance

10mA max.

2. Insulation resistance

500M ohms min.

100V DC

3. Withstanding voltage

No flashover or insulation breakdown

200V AC / 1 minute

5. Durability

20 cycles

6. Vibration

7. Shock

8. Humidity

96 hours at temperature of +40°C and humidity of 95%

9. Temperature cycle

10. Salt spray test

No excessive corrosion

5% salt water solution, 48 hours

Center contact: 20m ohms max.

Outer contact: 10m ohms max.

Waveform: sine half-wave, 3 cycles in each of the

3 axis

Temperature:-40°C/+5°C to +35°C/+90°C/+5°C to +35°C

Time: 30 min./ 3 min. / 30 min. / 3 min.

5 cycles

Frequency: 10 to 100 Hz, single amplitude of 1.5mm

5 cycles

Contact resistance

Center contact: 25m ohms max.

Outer contact: 15m ohms max.

No damage, cracks, or parts dislocation

1.3 Max.

1.35 Max.

Up to 3 GHz

3 to 6 GHz

No electrical discontinuity of 1 µs or longer

No damage, cracks, or parts dislocation

No electrical discontinuity of 1 µs or longer

No damage, cracks, or parts dislocation

Insulation resistance: 10M ohms min. (high humidity)

Insulation resistance: 500M ohms min. (dry)

No damage, cracks, or parts dislocation

Nominal characteristic impedance

Frequency range

50 ohms

DC to 6 GHz

Operating temperature range

Operating humidity

-40°C to +90°C

90% RH max.

Ratings

*V.S.W.R. Measurement System

Measured as shown on the block diagram below.

Note1: Measurement way of a W.FL Cable assembly (plug)

W.FL Cable assembly (plug) is measured with SMA conversion adapters

mated with W.FL plugs at both ends of a 100cm coaxial cable harness

Note2: Measurement way of a W.FL receptacle

W.FL receptacle, which is mounted on a 50 ohms glass epoxy board, is

measured with a SMA conversion adapter.

Network Analyzer

Test Set

Test Port

Termination

D.U.T

Test Port Cable

sMaterials / Finishes

Shell

Phosphor bronze

Silver plated

-------

Female center contact

Phosphor bronze

Gold plated

-------

Insulator

PBT

Color: Black

UL94V-0

Part

Material

Finish

Remarks

qPlug – right angle

qReceptacle

Male center contact

Brass

Gold plated

-------

Insulator

LCP

Color: Black

UL94V-0

Shell

Phosphor bronze

Silver plated

-------

Part

Material

Finish

Remarks

No damage, cracks, or parts dislocation

Contact resistance:

25m ohms max. (Center)

15m ohms max. (Outer)

The product information in this catalog is for reference only. Please request the Engineering Drawing for the most current and accurate design information.

All non-RoHS products have been discontinued, or will be discontinued soon. Please check the products status on the Hirose website RoHS search at www.hirose-connectors.com, or contact your Hirose sales representative.