6

554 SERIES

n

9.0 CONNECTION AND MOUNTING

The details below indicate the recommended mounting structure for panel and enclosure. The enclosure sup-

port to fix the touch panel must be over 1.0mm I width and must be outside the view (Transparent area). Also

ensure that the enclosure does not cause miss input by touching the view area.

The following diagram shows that the enclosure edge must be between the View area and the guaranteed ac-

tive area. Ensure space is allocated for the diodes, and we recommend that the material to fix the panel and

enclosure is elastic. Special design would be required to stop water ingress. The corners of the touch panel

are conductive so do not touch any metal parts after mounting.

Location

Detect

1.

Bottom

2.

Left

3.

Top

4.

Right

Top View (Picture, with conductive

side down)

(Drawing) with conductive connector and glass

side down. See page 1 for detail of connector exit

side which is left.

(Mating connector type FCI or equivalent

SFW4R-1STAE1-LF: for FPC)

0.8 mm min.

Connector

LCD

1.0 to 3.0 mm

Circuit Board

Transparent Area

Anti-input Area

Shock absorber to protect

the panel (eg rubber)

Upper Case

Input Area

Shock absorber

for protection

View Area

Input Panel

Wiring Area

5.1

Stiffener board 10.2