7

All Intersil U.S. products are manufactured, assembled and tested utilizing ISO9000 quality systems.

Intersil Corporation’s quality certifications can be viewed at www.intersil.com/design/quality

Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time without

notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be accurate and

reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third parties which may result

from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.

For information regarding Intersil Corporation and its products, see www.intersil.com

Operation of this equipment in a residential area may cause

harmful interference in which case the user will be required

to correct the interference at his own expense.

If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

FCC Guidelines for Human Exposure

The EIRP was measured for the lower, middle and highest

frequencies used by the transmitter. The results in Table 5

are based on a safe distance between antenna and

operator of eight inches.The equipment therefore fulfills the

requirements on power density for general population /

complies with the requirements of FCC Part 15.247 (b) (4)

and FCC OET Bulletin 65 including supplements A, B and C.

WARNING: Any changes or modifications of equipment not expressly

approved by Intersil could void the user’s authority to operate the equipment.

Caution:To comply with FCC RF exposure limits, a separation distance of at

least 20cm must be maintained between the antenna’s of this device and all

persons.

TABLE 5. POWER DENSITY CALCULATION

Ch.1

Ch.6

Ch.11

Measured EIRP

(mW)

63.8

66.2

69.3

Calculated Power

Density (mW/cm2)

0.051

0.053

0.055

ISL36356A-APDK