поискавой системы для электроныых деталей
  Russian  ▼
ALLDATASHEETRU.COM

X  

SI4709 датащи(PDF) 1 Page - Silicon Laboratories

номер детали SI4709
подробное описание детали  Si4708/09 ANTENNA, SCHEMATIC, LAYOUT, AND DESIGN GUIDELINES
Download  8 Pages
Scroll/Zoom Zoom In 100%  Zoom Out
производитель  SILABS [Silicon Laboratories]
домашняя страница  http://www.silabs.com
Logo SILABS - Silicon Laboratories

SI4709 датащи(HTML) 1 Page - Silicon Laboratories

  SI4709 Datasheet HTML 1Page - Silicon Laboratories SI4709 Datasheet HTML 2Page - Silicon Laboratories SI4709 Datasheet HTML 3Page - Silicon Laboratories SI4709 Datasheet HTML 4Page - Silicon Laboratories SI4709 Datasheet HTML 5Page - Silicon Laboratories SI4709 Datasheet HTML 6Page - Silicon Laboratories SI4709 Datasheet HTML 7Page - Silicon Laboratories SI4709 Datasheet HTML 8Page - Silicon Laboratories  
Zoom Inzoom in Zoom Outzoom out
 1 / 8 page
background image
Rev. 0.2 10/09
Copyright © 2009 by Silicon Laboratories
AN350
AN350
Si4708/09 A NTENNA, S CHEMATIC, L AYOUT, AND D ESIGN
G UIDELINES
1. Introduction
This document provides general Si4708/09 design guidelines and an FM antenna selection that includes
schematic, BOM, and layout and design checklist. All users should follow the Si4708/09 design guidelines
presented in Section 2 and headphone antenna design guidelines in Section 3. To get an in-depth knowledge
about the headphone antenna, the antenna theory and interface model is presented in the Appendix.
2. Si4708/09 2.5 x 2.5 mm QFN Schematic and Layout
This section shows the minimal schematic and layout options required for optimal Si4708/09 performance.
Population options are provided to support the layout for all 2.5 x 2.5 mm QFN devices, mitigate system noise, and
filter VCO energy.
2.1. Si4708/09 2.5 x 2.5 mm Design
C1 (22 nF) is a required bypass capacitor for VD supply pin 10. Place C1 as close as possible to the VD pin 10 and
GND pin 11. Place a VIA connecting C1 VD supply to the power rail such that the cap is closer to the Si4708/09
than the VIA. Route C1 GND directly and only to GND pin 11 with a wide, low inductance trace. These
recommendations are made to reduce the size of the current loop created by the bypass cap and routing, minimize
bypass cap impedance, and return all currents to the GND pad.
C2 (22 nF) is an optional bypass capacitor for VA supply pin 14 and may be placed to mitigate supply noise. Place
C2 as close as possible to the VA pin 14. Place a VIA connecting C2 VA supply to the power rail such that the cap
is closer to the Si4708/09 than the VIA. These recommendations are made to reduce the size of the current loop
created by the bypass cap and routing, minimize bypass cap impedance, and return all currents to the GND pad.
C3 (100 nF) is an optional bypass capacitor for the VIO supply pin 8 and may be placed to mitigate supply noise.
Place C3 as close as possible to the VIO pin 8 and the GND pin 11. Place a VIA connecting C3 VIO supply to the
power rail such that the cap is closer to the Si4708/09 than the VIA. Route C3 GND directly and only to GND pin 11
with a wide, low inductance trace. These recommendations are made to reduce the size of the current loop created
by the bypass cap and routing, minimize bypass cap impedance, and return all currents to the GND pad.
C4 (2–5 pF) is an optional filter capacitor for FMI pin 2 and may be placed to shunt VCO energy to GND and
prevent it from radiating from an antenna connected to the FMI pin. This filter is only required if regulatory testing
requires measuring emissions at the VCO frequency of 3 to 4 GHz and the antenna implementation is an efficient
radiator at these frequencies. Place C4 as close as possible to FMI pin 2 and RFGND pin 3. Place a VIA
connecting C4 FMI to another layer as needed such that the cap is closer to the Si4708/09 than the VIA.
C8 and C9 (0.39 µF) are ac coupling caps for receiver analog audio output from ROUT pin 12 and LOUT pin 13.
The input resistance of an amplifier, such as a headphone amplifier, and the capacitor will set the high pass pole
given by Equation 1. Placement location is not critical.
R1 (1 k
 or C5 (2-5 pF) are required for filtering when using GPO interrupts (polling not an issue). Place R1 on the
opposite side of the PCB as the tuner (as close to pin 15 as possible) and route the GPO trace to the system
controller on this layer. Alternatively, capacitor C5 (2-5 pF) may be placed as a filter capacitor also on the opposite
side of the tuner and connected directly to ground.
R2-R6 (25
–2 k) are optional series termination resistors and are used to mitigate system noise. The
recommended value of the resistors is 2 k
 for optimal edge rate and noise suppression. Confirm that timing
requirements are met with the selected series termination resistor value. Place the series termination resistors R2-
R6 as close to the host controller as possible.


Аналогичный номер детали - SI4709

производительномер деталидатащиподробное описание детали
logo
Silicon Laboratories
SI4709 SILABS-SI4709 Datasheet
999Kb / 2P
   EVALUATION BOARD QUICK-START GUIDE
SI4709 SILABS-SI4709 Datasheet
3Mb / 302P
   Si47XX PROGRAMMING GUIDE
SI4709 SILABS-SI4709 Datasheet
1Mb / 14P
   Si4708/09 PROGRAMMING GUIDE
SI4709 SILABS-SI4709 Datasheet
2Mb / 68P
   Si470X/1X/2X/3X/4X EVALUATION BOARD TEST PROCEDURE
SI4709 SILABS-SI4709 Datasheet
997Kb / 3P
   Broadcast FM Radio Tuner for Portable Applications
More results

Аналогичное описание - SI4709

производительномер деталидатащиподробное описание детали
logo
Silicon Laboratories
AN400 SILABS-AN400 Datasheet
1Mb / 20P
   Si474X ANTENNA, SCHEMATIC, LAYOUT, AND DESIGN GUIDELINES
AN383 SILABS-AN383 Datasheet
1Mb / 69P
   Si47XX ANTENNA, SCHEMATIC, LAYOUT, AND DESIGN GUIDELINES
AN738 SILABS-AN738 Datasheet
1Mb / 37P
   Si4825/36-A ANTENNA, SCHEMATIC, LAYOUT, AND DESIGN GUIDELINES
AN555 SILABS-AN555 Datasheet
1Mb / 38P
   Si483X-B/Si4820/24 ANTENNA, SCHEMATIC, LAYOUT, AND DESIGN GUIDELINES
AN602 SILABS-AN602 Datasheet
1Mb / 38P
   Si4822/26/27/40/44 ANTENNA, SCHEMATIC, LAYOUT, AND DESIGN GUIDELINES
logo
Wolfson Microelectronic...
WM7210-1702-MS5-M-REV1 WOLFSON-WM7210-1702-MS5-M-REV1 Datasheet
167Kb / 8P
   Schematic and Layout
logo
Silicon Laboratories
AN349 SILABS-AN349 Datasheet
1Mb / 14P
   Si4708/09 PROGRAMMING GUIDE
logo
Fairchild Semiconductor
AN-5061 FAIRCHILD-AN-5061 Datasheet
129Kb / 4P
   Layout Guidelines
logo
Silicon Laboratories
AN644 SILABS-AN644 Datasheet
1Mb / 15P
   Si477X LAYOUT GUIDELINES
logo
Fairchild Semiconductor
AN-1577 FAIRCHILD-AN-1577 Datasheet
622Kb / 6P
   SG1577A Layout Guidelines
More results


Html Pages

1 2 3 4 5 6 7 8


датащи скачать

Go To PDF Page


ссылки URL




Конфиденциальность
ALLDATASHEETRU.COM
Вашему бизинису помогли Аллдатащит?  [ DONATE ] 

Что такое Аллдатащит   |   реклама   |   контакт   |   Конфиденциальность   |   обмен ссыками   |   поиск по производителю
All Rights Reserved©Alldatasheet.com


Mirror Sites
English : Alldatasheet.com  |   English : Alldatasheet.net  |   Chinese : Alldatasheetcn.com  |   German : Alldatasheetde.com  |   Japanese : Alldatasheet.jp
Russian : Alldatasheetru.com  |   Korean : Alldatasheet.co.kr  |   Spanish : Alldatasheet.es  |   French : Alldatasheet.fr  |   Italian : Alldatasheetit.com
Portuguese : Alldatasheetpt.com  |   Polish : Alldatasheet.pl  |   Vietnamese : Alldatasheet.vn
Indian : Alldatasheet.in  |   Mexican : Alldatasheet.com.mx  |   British : Alldatasheet.co.uk  |   New Zealand : Alldatasheet.co.nz
Family Site : ic2ic.com  |   icmetro.com