поискавой системы для электроныых деталей |
|
UC1845A-SP датащи(PDF) 5 Page - Texas Instruments |
|
|
UC1845A-SP датащи(HTML) 5 Page - Texas Instruments |
5 / 28 page UC1845A-SP www.ti.com SLUSC14 – MAY 2015 8.5 Electrical Characteristics VCC = 15 V (1), R T = 10 kΩ, CT = 3.3 nF, TA = TJ = –55°C to 125°C (unless otherwise noted) (2) PARAMETER TEST CONDITIONS MIN TYP MAX UNIT REFERENCE 5962-8670408VxA 4.95 5 5.06 5962P8670411Vxx TJ = 25°C, IO = 1 mA, 4.94 5 5.06 Output voltage Pre-radiation V VCC = 15 V 5962P8670411Vxx 4.85 5.06 Post-radiation Line regulation VIN = 12 to 25 V 6 20 mV Load regulation IO = 1 to 20 mA 6 25 mV Temperature stability(3) (4) (5) 0.2 0.4 mV/°C Total output variation(3) Over line, load, and temperature 4.9 5.1 V Output noise variation 10 Hz ≤ ƒ ≤ 10 kHz, TJ = 25°C 50 μV Long-term stability(5) 1000 hours, TA = 125°C (3) 5 25 mV Short-circuit output current –30 –100 –180 mA OSCILLATOR Initial accuracy TJ = 25°C (6) 47 52 57 kHz Voltage stability VCC = 12 to 25 V 0.2% 1% Temperature stability TJ = –55°C to 125°C (3) 5% Amplitude VRT/CT peak to peak (3) 1.7 V TJ = 25°C 7.8 8.3 8.8 Discharge current V pin 4 = 2 V(7) mA TJ = Full range 7.5 8.8 ERROR AMPLIFIER Input voltage VComp = 2.5 V 2.45 2.50 2.55 V Input bias current –0.3 –1 μA Open-loop voltage gain VO = 2 to 4 V 65 90 dB Unity-gain bandwidth TJ = 25°C (3) 0.7 1 MHz PSRR VCC = 12 to 25 V 60 70 dB Output sink current VFB = 2.7 V, VComp = 1.1 V 2 6 mA Output source current VFB = 2.3 V, VComp = 5 V –0.5 –0.8 mA High-level output voltage VFB = 2.3 V, RL = 15 kΩ to ground 5 6 V Low-level output voltage VFB = 2.7 V, RL = 15 kΩ to VREF 0.7 1.1 V CURRENT SENSE Gain(8) (9) 2.85 3 3.15 V/V Maximum input signal VComp = 5 V (8) 0.9 1 1.1 V PSRR VCC = 12 to 25 V (8) 70 dB Input bias current –2 –10 μA Delay to output VISENSE = 0 to 2 V (3) 150 300 ns OUTPUT (1) Adjust VCC above the start threshold before setting at 15 V. (2) See Mechanical, Packaging, and Orderable Information for radiation improved devices. (3) Parameters ensured by design and/or characterization, if not production tested. (4) Temperature stability, sometimes referred to as average temperature coefficient, is described by the equation: Temperature Stability = VREF (max) – VREF (min) / TJ (max) – TJ (min). VREF (max) and VREF (min) are the maximum and minimum reference voltage measured over the appropriate temperature range. Note that the extremes in voltage do not necessarily occur at the extremes in temperature. (5) Parameter applies only for 5962-8670408VxA (6) Output frequency is one-half oscillator frequency for UC1845A. (7) This parameter is measured with RT = 10 kΩ to VREF. This contributes approximately 300 μA of current to the measurement. The total current flowing into the RT or CT pin will be approximately 300 μA higher than the measured value. (8) Parameter measured at trip point of latch with VFB = 0 V. (9) Gain defined as: G = ΔVComp / ΔVISENSE; VISENSE = 0 to 0.8 V. Copyright © 2015, Texas Instruments Incorporated Submit Documentation Feedback 5 Product Folder Links: UC1845A-SP |
Аналогичный номер детали - UC1845A-SP |
|
Аналогичное описание - UC1845A-SP |
|
|
ссылки URL |
Конфиденциальность |
ALLDATASHEETRU.COM |
Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |