LCC600 Data Sheet

Environmental Specifications

Operating temperature range

-40 °C to +85 °C Baseplate temperature

Storage temperature

-40 °C to +85 °C

Humidity

10% to 95%

Altitude

16,402 ft (Operating) / 50,000 ft (Non-Operating)

Shock

MIL-STD-810F 516.5 Procedure I, VI

Vibration

MIL-STD-810F 514.5 Cat. 4, 10

Ingress protection

IP65 (for suffix “-4P”)

MTBF (calculated)

>2M Hrs, 25 °C per SR-332 Issue 3

Electromagnetic immunity

Designed to meet EN61000-4-3, -4, -5, -8, -11 (Level 3); EN61000-4-2 (Level 4); EN60601-1-2 and EN55024

For H suffix, Level 4 for EN61000-4-5

Electrical Specifications

Output

Output rating

See Ordering Information table

Standby output

5.0 Vdc @ 1.5 A Max

Set point

± 0.5%

Factory set point

Total regulation

Main Output: ± 2.0%

5 Vsb: ± 5%

Combined Line / Load / Temperature

Rated load

600 W maximum

600 W from -40 °C to 85 °C Baseplate Temp. Derate output

to 28 W @ 95 °C Baseplate Temp

Minimum load

0 A

For both Main and 5 Vsb Outputs

Output voltage adjust range

See Ordering Information table

Max power limited to 600 W

Output noise

Main Output: 1.0% max p-p

5 Vsb: 60 mV max p-p

Measured with 0.1 μF Ceramic and 10 μF Tantalum Cap,

20 MHz BW

Remote sense

Compensation up to 500 mV

Pin 10: +Vout_RS / Pin4: -Vout_RS

Over current protection

105 - 130% of full load current

Default is Shutdown mode with Auto-retry every 2~4 sec.

Output latches after 20 sec of continuous OCP fault

presence. Restart after latch possible through AC recycle,

Inhibit toggle or through PMBus.

Over voltage protection

125 - 145% Vo, nom Main Output

125 - 130% 5 Vsb

Latching / AC Recyle or Inhibit toggle required for PSU

restart

Over temperature protection

> 95 °C Baseplate temperature

Output Shutdown / Auto-recovery

AC_OK

Open Collector; 0.8 Vdc max / 10 mA

Active low when AC is present

DC_OK

Open Collector; 0.8 Vdc max / 10 mA

Active low when Main Output is within regulation

Remote inhibit

Contact Closure

Pin 19: Open/Float = ON; Close/Ground = OFF

# Units in parallel operation

Qualified up to 5 units in parallel. Consult factory if

more than 5 are required.

Pin 5: IShare pin for main output only.

Output dimming

0-10 Vdc external voltage;

0-100 kOhm external resistance

Consult with productsupport.ep@artesyn.com