408-2823

2 of 6

Rev Z

Figure 2

5. Holding the wire in place, squeeze the tool

handles together until the ratchet releases. Allow

the tool handles to open FULLY.

6. Remove crimped terminal or splice from the tool.

7. If crimping a splice, position the uncrimped wire

barrel in the crimping chamber. Make sure to seat

the splice window indent on the locator assembly.

Repeat Steps 3 through 6.

Damaged or worn terminals must not be used.

Terminals may be removed from the wire,

discarded, and replaced with new ones.

4. CRIMP INSPECTION

— Check that the crimp dot code on the color-coded

insulation indicates the crimping chamber used. Refer

to Figure 2.

— Check that the crimp is centered on the wire

barrel. See Figure 4.

— Make sure that the wire insulation does not enter

the wire barrel. See Figure 4.

— Check that the wire end is flush with or slightly

beyond the end of the wire barrel. See Figure 4.

CAUTION

!