3

Patient Care Unit with Standard Laminate or Optional Terreon® Top

Installation Instructions

LC700, LC750

Bradley Corporation • 215-1171 Rev. D; EN 04-1037

8/16/04

Installation Instructions

Step 1: Unpack the Patient Care Unit

1. Remove the packaging around the Patient Care Unit.

2. Remove the door linkage by removing the nut fastened

on the linkage bracket (see Figure 1). Note the location

of the rod on the linkage bracket.

3. Lift out the trim piece around the water closet on the

cabinet floor (see Figure 2).

4. Unfasten the two panel clips and slide the sliding back

panel so that the panel lips unlock (see Figure 2). Bring

the panel out of the front of the cabinet.

5. Remove the cabinet floor by removing the two screws

holding the floor in place and sliding the

cabinet floor out.

6. Remove the flexible hose, hose clamp,

inlet nut and pipe from the water closet

(see Figure 3).

7. Unbolt the water closet and cabinet

assembly from the floor/template. Discard

the shipping hardware for the water closet

and cabinet, but DO NOT discard the

plywood floor/template.

Figure 2

Figure 1

DOOR

LINKAGE

ARM

LINKAGE

BRACKET

CABINET FLOOR

SCREWS

STATIONARY

BACK PLATE

Figure 3

PANEL

CLIP

CABINET

FLOOR

TRIM

PIECE

SLIDING BACK

PANEL

INLET NUT

FLEXIBLE

HOSE

HOSE CLAMP

PIPE