Analog Power

AMA920N

Package Information

Note:

1.

All Dimension Are In mm.

2.

Package Body Sizes Exclude Mold Flash, Protrusion Or Gate Burrs. Mold Flash, Protrusion Or Gate Burrs Shall Not

Exceed 0.10 mm Per Side.

3.

Package Body Sizes Determined At The Outermost Extremes Of The Plastic Body Exclusive Of Mold Flash, Tie Bar

Burrs, Gate Burrs And Interlead Flash, But Including Any Mismatch Between The Top And Bottom Of The Plastic Body.

4.

The Package Top May Be Smaller Than The Package Bottom.

5.

Dimension "B" Does Not Include Dambar Protrusion. Allowable Dambar Protrusion Shall Be 0.08 mm Total In Excess

Of "B" Dimension At Maximum Material Condition. The Dambar Cannot Be Located On The Lower Radius Of The

Foot.

© Preliminary

5

Publication Order Number:

DS-AMA920N-2010