GENNUM CORPORATION

522 - 80 - 00

4

Fig. 1 Test Setup for Figures 5 and 6

Carrier Detect Response Time

Carrier Applied,

-3

-

µs

7

6

Carrier Removed,

-30

-

NOTES

1. TYPICAL - measured on characterization board.

2. Characterized 6 sigma rms.

3. IJT measured with sinusoidal modulation beyond Loop Bandwidth (at 6.5MHz).

4. Synchronous switching refers to switching the input data from one source to another source which is at the same data rate (ie. line 10 switching

for component NTSC).

5. Carrier Loss Time refers to the response of the SDO output from valid re-clocked input data to mute mode when the input signal is removed.

6. Using the DDI input, A/D=0.

7. Using the SDI input, A/D=1.

TEST LEVELS

1. Production test at room temperature and nominal supply voltage with guardbands for supply and temperature ranges.

2. Production test at room temperature and nominal supply voltage with guardbands for supply and temperature ranges using correlated test.

3. Production test at room temperature and nominal supply voltage.

4. QA sample test.

5. Calculated result based on Level 1,2, or 3.

6. Not tested. Guaranteed by design simulations.

7. Not tested. Based on characterization of nominal parts.

8. Not tested. Based on existing design/characterization data of similar product.

AC ELECTRICAL CHARACTERISTICS

PARAMETER

CONDITIONS

MIN

TYPICAL

1

MAX

UNITS

NOTES

TEST

LEVEL

CHARACTERIZATION

BOARD

GS9028

CABLE

DRIVER

TEKTRONIX

GigaBERT

1400

ANALYZER

TEKTRONIX

GigaBERT

1400

TRANSMITTER

BELDEN 8281

CABLE

DATA

DATA

CLOCK

TRIGGER