AD7787

Rev. 0 | Page 5 of 20

TIMING CHARACTERISTICS

from a voltage level of 1.6 V (see Figure 3 and Figure 4).

Table 2.

Parameter

Unit

Conditions/Comments

100

ns min

SCLK High Pulse Width

100

ns min

SCLK Low Pulse Width

Read Operation

0

ns min

CS Falling Edge to DOUT/RDY Active Time

60

ns max

80

ns max

0

ns min

SCLK Active Edge to Data Valid Delay2

60

ns max

80

ns max

10

ns min

Bus Relinquish Time after CS Inactive Edge

80

ns max

100

ns max

SCLK Inactive Edge to CS Inactive Edge

10

ns min

SCLK Inactive Edge to DOUT/RDY High

Write Operation

0

ns min

CS Falling Edge to SCLK Active Edge Setup Time2

30

ns min

Data Valid to SCLK Edge Setup Time

25

ns min

Data Valid to SCLK Edge Hold Time

0

ns min

CS Rising Edge to SCLK Edge Hold Time

extrapolated back to remove the effects of charging or discharging the 50 pF capacitor. This means that the times quoted in the timing characteristics are the true bus

relinquish times of the part and, as such, are independent of external bus loading capacitances.

4

RDY returns high after a read of the ADC. In single conversion mode and continuous conversion mode, the same data can be read again, if required, while RDY is high,

although care should be taken to ensure that subsequent reads do not occur close to the next output update. In continuous read mode, the digital word can be read

only once.