4

CS1W-CLK

Controller Link Support Boards, New Models

Controller Link Support Boards, Old Models

New models are fully compatible with old models and provide enhanced functionality, such as an increase in the number of send words from 1,000

to 4,000 words. Both types can be used simultaneously on the same network. Select a new model when ordering.

Note: The CD-ROM contains the following software.

• Controller Link (PCI) Driver

• FinsGataway Version 2003 (PCI-CLK Edition)

• FinsGataway Version 3 (PCI-CLK Edition)

• Setup Diagnostic Utility

• C Library

Repeater Units

Using Repeater Units enables T-branches and long-distance wiring for Wired Controller Link networks, 62-node configurations, and converting

part of the network to optical cable.

Note: 1. When using wire-to-optical (H-PCF) cable, use a H-PCF cable (for both Controller Link and SYSMAC LINK) or a H-PCF optical fiber cable

with connector.

2. When using wire-to-optical (GI) cable, use a GI optical cable (for Controller Link).

Relay Terminal Block

Controller Link Units can be replaced without stopping the communications of the entire network if a Relay Terminal Block is installed in advance

on the Unit in a Wired Controller Link network. Relay Terminal Blocks cannot be used on Controller Link Support Boards.

Duplex Optical Fiber Cable (H-PCF Cable)

This cable is used to connect Units in active mode (ACT) and standby mode (STB) in a CS1D Duplex System.

Product name

Specifications

Accessories

Model

Standards

Communications

cable

Communications type

Controller Link

Support Board

for PCI Bus

Wired shielded

twisted-pair cable

Data links and message

service

• CD-ROM × 1 (See note.)

• INSTALLATION GUIDE (W467) × 1

• Communications connector × 1

3G8F7-CLK23-E

CE

H-PCF optical model

• CD-ROM × 1 (See note.)

• INSTALLATION GUIDE (W467) × 1

• Optical Fiber Cable Bracket × 1

• Power supply connector × 1

3G8F7-CLK13-E

GI optical model

3G8F7-CLK53-E

Product name

Specifications

Accessories

Model

Note: New models are

listed above.

Standards

Communications

cable

Communications type

Controller Link

Support Board

for PCI Bus

Wired shielded

twisted-pair cable

Data links and message

service

• CD-ROM × 1 (See note.)

• INSTALLATION GUIDE (W422) × 1

• Communications connector × 1

3G8F7-CLK21-EV1

CE

H-PCF optical model

• CD-ROM × 1 (See note.)

• INSTALLATION GUIDE (W422) × 1

• Optical Fiber Cable Bracket × 1

• Power supply connector × 1

3G8F7-CLK12-EV1

GI optical model

3G8F7-CLK52-EV1

Name

Specifications

Model

Standards

Controller Link

Repeater Unit

Wire-to-Wire Model

CS1W-RPT01

UC1, CE

Wire-to-Optical (H-PCF) Model (See note 1.)

CS1W-RPT02

Wire-to-Optical (GI) Model (See note 2.)

CS1W-RPT03

Name

Specifications

Model

Standards

Relay Terminal Blocks for

Wired Controller Link Units

Used for Wired Controller Link Units (set of 5)

CJ1W-TB101

−

Name

Application

Specifications

Model

Standards

Duplex Optical Fiber Cable

CS1W-CLK13 or

CS1W-CLK12-V1 in a CS1D system

H-PCF cable for connecting Duplex Controller Link Units

Cable length: 50 cm

CS1D-CN051

−

CS1W-RPT01

PWR

T/R1

T/R2

SL1

TER SW

TER SW

ON

SL2

DC24V

INPUT

1 BAUD

2 RATE

SW1