LA75694M

PS No.A0251-10/10

Note 1) Unless otherwise specified for VIF test, apply the VCC voltage to the IF AGC and adjust the VCO coil so that

oscillation occurs at 45.75MHz.

2) Unless otherwise specified, the SW1 must be ON.

Specifications of any and all SANYO Semiconductor products described or contained herein stipulate the

performance, characteristics, and functions of the described products in the independent state, and are

not guarantees of the performance, characteristics, and functions of the described products as mounted

in the customer's products or equipment. To verify symptoms and states that cannot be evaluated in an

independent device, the customer should always evaluate and test devices mounted in the customer's

products or equipment.

SANYO Semiconductor Co., Ltd. strives to supply high-quality high-reliability products. However, any

and all semiconductor products fail with some probability. It is possible that these probabilistic failures

could give rise to accidents or events that could endanger human lives, that could give rise to smoke or

fire, or that could cause damage to other property. When designing equipment, adopt safety measures

so that these kinds of accidents or events cannot occur. Such measures include but are not limited to

protective circuits and error prevention circuits for safe design, redundant design, and structural design.

In the event that any or all SANYO Semiconductor products (including technical data,services) described

or contained herein are controlled under any of applicable local export control laws and regulations, such

products must not be exported without obtaining the export license from the authorities concerned in

accordance with the above law.

No part of this publication may be reproduced or transmitted in any form or by any means, electronic or

mechanical, including photocopying and recording, or any information storage or retrieval system, or

otherwise, without the prior written permission of SANYO Semiconductor Co., Ltd.

Any and all information described or contained herein are subject to change without notice due to

product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification"

for the SANYO Semiconductor product that you intend to use.

Information (including circuit diagrams and circuit parameters) herein is for example only; it is not

guaranteed for volume production. SANYO Semiconductor believes information herein is accurate and

reliable, but no guarantees are made or implied regarding its use or any infringements of intellectual

property rights or other rights of third parties.

This catalog provides information as of April, 2006. Specifications and information herein are subject

to change without notice.