2 Honeywell • Sensing and Control

SS360PT/SS460P

257 ºF] except where otherwise specified.)

Characteristic

Condition

MIn.

Typ.

Max.

Unit

Supply voltage:

SS360PT

SS360PT

SS460P

-40 °C to 110 °C [-40 °F to 230 °F]

125 °C [257 °F]

-40 °C to 125 °C [-40 °F to 257 °F]

3

3

3

–

–

–

24

16

24

Vdc

Supply current

–

–

–

3.5

–

6

10

mA

Vsat

Gauss >55

–

–

0.6

V

Output leakage current

Gauss >55

–

–

10

µA

Internal pull-up resistor

–

7.5

10.0

12.5

kOhm

Rise/fall time

–

–

1.5

µs

Thermal resistance:

SS360PT (SOT-23)

SS460P (flat TO-92-style)

–

–

–

–

303

233

–

–

°C/W

Operate

-40 °C to 125 °C [-40 °F to 257 °F]

5

30

55

Gauss

Release

-40 °C to 125 °C [-40 °F to 257 °F]

-55

-30

-5

Gauss

Differential

-40 °C to 125 °C [-40 °F to 257 °F]

40

60

80

Gauss

Operating temperature

-40 [-40]

–

125 [257]

°C [°F]

Storage temperature:

SS360PT

SS460P

–

–

-40 [-40]

-40 [-40]

–

–

150 [302]

165 [329]

°C [°F]

POTENTIAL APPLICATIONS

Industrial/Commercial

• Brushless dc motor commutation for white goods and other

appliances

• Flow-ratesensing

• SpeedandRPMsensing

• Tachometer,counterpickup

• Motorandfancontrol

NOTICE

Bipolar Hall-effect sensor ICs may have an initial output in either the ON or OFF state if powered up with an applied magnetic field

in the differential zone (applied magnetic field >Brp and <Bop). Honeywell recommends allowing 10 µs for output voltage to stabilize

after supply voltage has reached its normal operating value.

Characteristic

MIn.

Typ.

Max.

Unit

Supply voltage

-26.0

–

26.0

V

Applied output voltage

-0.5

–

26.0

V

Output current

–

–

20

mA

Magnetic flux

–

–

no limit

Gauss

Note 1: Absolute maximum ratings are the extreme limits that the device will withstand without damage to the device. However, the

electrical and mechanical characteristics are not guaranteed as the maximum limits (above recommended operating conditions) are ap-

proached, nor will the device necessarily operate at absolute maximum ratings.

NOTICE

The magnetic field strength (Gauss) required to cause the switch to change state (operate and release)

will be as specified in the magnetic characteristics. To test the switch against the specified magnetic

characteristics, the switch must be placed in a uniform magnetic field.