поискавой системы для электроныых деталей |
|
TLP152 датащи(PDF) 3 Page - Toshiba Semiconductor |
|
TLP152 датащи(HTML) 3 Page - Toshiba Semiconductor |
3 / 10 page TLP152 3 7. 7. 7. 7. Absolute Maximum Ratings (Note) (Unless otherwise specified, T Absolute Maximum Ratings (Note) (Unless otherwise specified, T Absolute Maximum Ratings (Note) (Unless otherwise specified, T Absolute Maximum Ratings (Note) (Unless otherwise specified, Taaaa = 25 = 25 = 25 = 25 )))) LED Detector Common Characteristics Input forward current Peak transient input forward current Input reverse voltage Input power dissipation Peak high-level output current Peak low-level output current Output voltage Supply voltage Output power dissipation Operating temperature Storage temperature Lead soldering temperature Isolation voltage (Ta = -40 to 100) (Ta = -40 to 100) (10 s) AC, 1 min, R.H. ≤ 60%, Ta = 25 Symbol IF IFPT VR PD IOPH IOPL VO VCC PO Topr Tstg Tsol BVS Note (Note 1) (Note 2) (Note 2) (Note 3) (Note 4) Rating 20 1 5 40 -2.5 +2.5 35 35 260 -40 to 100 -55 to 125 260 3750 Unit mA A V mW A V mW Vrms Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note 1: Pulse width (PW) ≤ 1 µs, 300 pps Note 2: Exponential waveform. Pulse width ≤ 0.2 µs, f ≤ 15 kHz, VCC = 20V, Ta = -40 to 100 Exponential waveform. Pulse width ≤ 0.08 µs, f ≤ 25 kHz, VCC = 15V, Ta = -40 to 100 Note 3: ≥ 2 mm below seating plane. Note 4: This device is considered as a two-terminal device: Pins 1, and 3 are shorted together, and pins 4, 5 and 6 are shorted together. 8. 8. 8. 8. Recommended Operating Conditions (Note) Recommended Operating Conditions (Note) Recommended Operating Conditions (Note) Recommended Operating Conditions (Note) Characteristics Input on-state current Input off-state voltage Peak high-level output current Peak low-level output current Operating frequency Symbol IF(ON) VF(OFF) IOPH IOPL f Note (Note 1) (Note 2) Min 10 0 Typ. Max 15 0.8 -2.0 +2.0 250 Unit mA V A kHz Note: The recommended operating conditions are given as a design guide necessary to obtain the intended performance of the device. Each parameter is an independent value. When creating a system design using this device, the electrical characteristics specified in this datasheet should also be considered. Note: A ceramic capacitor (0.1 µF) should be connected between pin 6 and pin 4 to stabilize the operation of a high- gain linear amplifier. Otherwise, this photocoupler may not switch properly. The bypass capacitor should be placed within 1 cm of each pin. Note 1: The rise and fall times of the input on-current should be less than 0.5 µs. Note 2: Exponential waveform. IOPH ≥ -0.65 A (≤ 80 ns), IOPL ≤ 0.65 A (≤ 80 ns), Ta = 100, VCC = 20V 2012-09-14 Rev.3.0 |
Аналогичный номер детали - TLP152 |
|
Аналогичное описание - TLP152 |
|
|
ссылки URL |
Конфиденциальность |
ALLDATASHEETRU.COM |
Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |