поискавой системы для электроныых деталей |
|
LM1971N датащи(PDF) 4 Page - National Semiconductor (TI) |
|
|
LM1971N датащи(HTML) 4 Page - National Semiconductor (TI) |
4 / 11 page Pin Description V REFIN (1): The VREFIN pin provides the reference for the analog input signal. This pin should be biased at half of the supply voltage, V DD, as shown in Figure 1 and Figure 6. OUT (2): The attenuated analog output signal comes from this pin. GND (3): The GND pin references the digital input signals and is the lower voltage reference for the IC. Typically this pin would be labeled “V SS” but the ground reference for the digital logic input control is tied to this same point. With a higher pin-count there would generally be separate pins for these functions; V SS and Logic Ground. It is intended that the LM1971 always be operated using a single volt- age supply configuration, for which pin 3 (GND) should al- ways be at system ground. If a bipolar or split-supply con- figuration are desired, level shifting circuitry is needed for the digital logic control pins as they would be referenced through pin 3 which would be at the negative supply. It is highly recommended, however, that the LM1971 be used in a unipolar or single-supply configuration. LOAD (4): The LOAD input accepts a TTL or CMOS level signal. This is the enable pin of the device, allowing data to be clocked in while this input is low (0V). The GND pin is the reference for this signal. DATA (5): The DATA input accepts a TTL or CMOS level signal. This pin is used to accept serial data from a micro- controller that will be latched and decoded to change the channel’s attenuation level. The GND pin is the reference for this signal. CLOCK (6): The CLOCK input accepts a TTL or CMOS level signal. The clock input is used to load data into the internal shift register on the rising edge of the input clock waveform. The GND pin is the reference for this signal. V DD (7): The positive voltage supply should be placed to this pin. IN (8): The analog input signal should be placed to this pin. Typical Performance Characteristics Supply Current vs Supply Voltage DS012353-10 Supply Current vs Temperature DS012353-11 Noise Floor Analog Measurement DS012353-12 THD+Nvs Freq and Amp DS012353-13 THD+Nvs Freq and Amp DS012353-14 Noise Floor Spectrum by FFT DS012353-15 www.national.com 4 |
Аналогичный номер детали - LM1971N |
|
Аналогичное описание - LM1971N |
|
|
ссылки URL |
Конфиденциальность |
ALLDATASHEETRU.COM |
Вашему бизинису помогли Аллдатащит? [ DONATE ] |
Что такое Аллдатащит | реклама | контакт | Конфиденциальность | обмен ссыками | поиск по производителю All Rights Reserved©Alldatasheet.com |
Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
Family Site : ic2ic.com |
icmetro.com |