GS8182Q08/09/18/36BD-333/300/250/200/167/133

Specifications cited are subject to change without notice. For latest documentation see http://www.gsitechnology.com.

Rev: 1.03d 11/2011

9/36

© 2007, GSI Technology

Power-Up Sequence for SigmaQuad-II SRAMs

SigmaQuad-II SRAMs must be powered-up in a specific sequence in order to avoid undefined operations.

Power-Up Sequence

1. Power-up and maintain Doff at low state.

2. After power is achieved and clocks (K, K, C, C) are stablized, change Doff to high.

3. An additional 1024 clock cycles are required to lock the DLL after it has been enabled.

Note:

If you want to tie Doff high with an unstable clock, you must stop the clock for a minimum of 30 ns to reset the DLL after

the clocks become stablized.

DLL Constraints

operating clock frequency.

• If the incoming clock is not stablized when DLL is enabled, the DLL may lock on the wrong frequency and cause

undefined errors or failures during the initial stage.

Note:

If the frequency is changed, DLL reset is required. After reset, a minimum of 1024 cycles is required for DLL lock.